24
undo jumboframe enable
View
Ethernet interface view, port group view
Default level
2: System level
Parameters
.None
Description
Use the jumboframe enable command to allow frames no longer than 9216 bytes to pass through an
Ethernet interface.
Use the undo jumboframe enable command to prevent frames longer than 1536 bytes from passing
through an Ethernet interface.
By default, the device allows frames no larger than 9216 bytes to pass through an Ethernet interface.
You can configure length of jumbo frames on a port (in Ethernet interface view, port-group view) to allow
them to pass through Ethernet interfaces.
• Execution of this command under Ethernet interface view will only apply the configurations to the
current Ethernet interface.
• Execution of this command under port group view will apply the configurations to the Ethernet
interface(s) in the port group.
Examples
# Enable jumbo frames to pass through all the Ethernet interfaces in the manual port group named
group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member GigabitEthernet 1/0/1
[Sysname-port-group-manual-group1] jumboframe enable
# Enable jumbo frames to pass through GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] jumboframe enable
link-delay
Syntax
link-delay delay-time
undo link-delay
View
Ethernet interface view
Default level
2: System level
To Next Page
Loading...
