86
Parameters
None
Description
Use the link-aggregation mode dynamic command to configure an aggregation group to work in
dynamic aggregation mode.
Use the undo link-aggregation mode command to restore the default.
By default, an aggregation group works in static aggregation mode.
To change the aggregation mode of an aggregation group that contains member ports, remove all the
member ports from the aggregation group first.
Examples
# Configure the aggregation group corresponding to Bridge-Aggregation 1 to work in dynamic
aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
port link-aggregation group
Syntax
port link-aggregation group number
undo port link-aggregation group
View
Ethernet interface view
Default level
2: System level
Parameters
number: Specifies an aggregate interface number corresponding to an aggregation group, ranging
from 1 to 128.
Description
Use the port link-aggregation group command to assign the current Ethernet interface to the specified
aggregation group.
Use the undo port link-aggregation group command to remove the current Ethernet interface from the
aggregation group to which it belongs.
An Ethernet interface can belong to only one aggregation group.
To achieve optimal load sharing effect, ensure that a link aggregation group contains only one type of
port. For example, specify only Gigabit Ethernet ports or 10-Gigabit Ethernet ports.
Examples
# Assign Layer 2 Ethernet interface GigabitEthernet 1/0/1 to Layer 2 aggregation group 1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-aggregation group 1
To Next Page
Loading...
Need help?
General