149
port hybrid vlan
Syntax
port hybrid vlan vlan-id-list { tagged | untagged }
undo port hybrid vlan vlan-id-list
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
vlan-id-list: Specifies a list of VLANs that the hybrid ports will be assigned to, in the format of [ vlan-id1
[ to vlan-id2 ] ]&<1-10>, where vlan-id ranges from 1 to 4094 and &<1-10> indicates that you can
specify up to 10 VLAN IDs or VLAN ID ranges. Make sure that the specified VLANs already exist.
tagged: Configures the port(s) to send the packets of the specified VLAN(s) with the tags kept.
untagged: Configures the port to send the packets of the specified VLAN(s) with the tags removed.
Description
Use the port hybrid vlan command to assign the current hybrid port(s) to the specified VLAN(s).
Use the undo port hybrid vlan command to remove the current hybrid port(s) from the specified VLAN(s).
By default, a hybrid port only allows packets from VLAN 1 to pass through untagged.
A hybrid port can carry multiple VLANs. If you execute the port hybrid vlan command multiple times, the
VLANs the hybrid port carries are the set of VLANs specified by vlan-id-list in each execution.
In port group view, this command applies to all ports in the port group. For more information about port
groups, see the Layer 2—LAN Switching Configuration Guide.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
• If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
• If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
For more information about Layer 2 aggregate interfaces, see the Layer 2—LAN Switching
Configuration Guide.
Related commands: port link-type.
Examples
# Assign the hybrid port GigabitEthernet 1/0/1 to VLAN 2, VLAN 4, and VLAN 50 through VLAN 100,
and configure GigabitEthernet 1/0/1 to send packets of these VLANs with tags kept.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type hybrid
[Sysname-GigabitEthernet1/0/1] port hybrid vlan 2 4 50 to 100 tagged
# Assign hybrid ports in port group 2 to VLAN 2, and configure these hybrid ports to send packets of
VLAN 2 with VLAN tags removed.
To Next Page
Loading...
