H3C S5120-EI Series - Display Link-Aggregation Load-Sharing Mode

72
Examples
# Display the local system ID.
<Sysname> display lacp system-id
Actor System ID: 0x8000, 0000-fc00-6504
Table 16 Output description
Field Description
Actor System ID: 0x8000,
0000-fc00-6504
The local system ID, which comprises the LACP system priority (0x8000
in this sample output) and the system MAC address (0000-fc00-6504 in
this sample output).
display link-aggregation load-sharing mode
Syntax
display link-aggregation load-sharing mode [ interface [ bridge-aggregation interface-number ] ] [ |
{ begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
bridge-aggregation: Displays the load sharing criterion or criteria of the aggregation group
corresponding to the specified Layer 2 aggregate interface.
interface-number: Specifies the number of an existing aggregate interface.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256 characters.
Description
Use the display link-aggregation load-sharing mode command to display global or group-specific
link-aggregation load sharing criterion or criteria.
To display the global link-aggregation load sharing criterion or criteria, run the command without the
interface keyword.
To display all the group-specific load sharing criteria, run the command with the interface keyword, but
do not specify a particular interface.
To display the load sharing criterion or criteria of a particular aggregation group, perform the command
with the aggregate interface specified.
The bridge-aggregation keyword becomes available only after you create Layer 2 aggregate interfaces
on the device.