H3C S5120-EI Series - Garp Timer Join; Garp Timer Leave

192
Related commands: display garp timer and garp timer join.
Examples
# Set the GARP Hold timer to 15 centiseconds, assuming that the Join timer is 30 centiseconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] garp timer hold 15
garp timer join
Syntax
garp timer join timer-value
undo garp timer join
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default level
2: System level
Parameters
timer-value: Join timer setting (in centiseconds), which must be a multiple of 5 in the range of two times
the Hold timer (inclusive) and half of the Leave timer (inclusive).
Description
Use the garp timer join command to set the GARP Join timer for an Ethernet port, Layer-2 aggregate
interface, or all ports in a port group.
Use the undo garp timer join command to restore the default of the GARP Join timer. This may fail if the
default is beyond the valid value range for the Join timer.
By default, the Join timer is set to 20 centiseconds.
Related commands: display garp timer, garp timer hold, and garp timer leave.
Examples
# Set the GARP Join timer to 25 centiseconds, assuming that both the Hold timer and the Leave timer are
using the default.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] garp timer join 25
garp timer leave
Syntax
garp timer leave timer-value
undo garp timer leave
View
Ethernet interface view, Layer-2 aggregate interface view, port group view