195
Default level
2: System level
Parameters
fixed: Sets the GVRP registration mode to fixed.
forbidden: Sets the GVRP registration mode to forbidden.
normal: Sets the GVRP registration mode to normal.
Description
Use the gvrp registration command to configure the GVRP registration mode on a port (in Ethernet or
Layer-2 aggregate interface view) or all ports in a port group (in port group view).
Use the undo gvrp registration command to restore the default on a port, or on all ports in a port group
depending on the view the command is executed.
The default GVRP registration mode is normal.
Note that, this command is only available on trunk ports.
Related commands: display garp statistics.
Examples
# Set the GVRP registration mode to fixed on port GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] gvrp registration fixed
reset garp statistics
Syntax
reset garp statistics [ interface interface-list ]
View
User view
Default level
2: System level
Parameters
interface interface-list: Specifies one or multiple ports for which the GARP statistics are to be cleared. You
can provide up to 10 port lists, by each of which you can specify a single port in the form of
interface-type interface-number, or a port range in the form of interface-type interface-number1 to
interface-type interface-number2, where the end port number specified by interface-number2 must be
greater than the start port number specified by interface-number1. If no ports are specified, this
command clears the GARP statistics on all ports.
Description
Use the reset garp statistics command to clear the GARP statistics on the specified ports or all ports if no
ports are specified.
The cleared statistics include the statistics about GVRP protocol packets sent, received and dropped. You
can use this command in conjunction with the display garp statistics command to display GARP statistics.
To Next Page
Loading...
