H3C S5120-EI Series - Display Interface Brief

10
Field Description
DOWN ( Link-Aggregation
interface down )
The interface is physically down because the aggregate interface
corresponding to the aggregation group to which it belongs was shut down
with the shutdown command.
DOWN ( OAM connection
failure )
The interface is physically down because an OAM connection fails to be
established on it or the current OAM connection is disconnected.
DOWN ( DLDP connection
failure )
The interface is physically down because a DLDP connection fails to be
established on it or the current DLDP connection is disconnected.
DOWN ( Loopback
detection-protected )
The interface is shut down because a loop is detected on it.
DOWN ( BPDU-protected ) The interface is shut down by the BPDU guard function.
DOWN ( Monitor-Link uplink
down )
The interface is physically down because the uplink of the monitor link group
to which it belongs is down.
display interface brief
Syntax
display interface [ interface-type [ interface-number ] ] brief [ | { begin | exclude | include }
regular-expression ]
display interface [ interface-type ] brief down [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
down: Displays information about interfaces in DOWN state and the relevant causes.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256 characters.
Description
Use the display brief interface command to display brief interface information.
• If neither interface type nor interface number is specified, this command displays information about
all interfaces.
• If only interface type is specified, this command displays information about interfaces of the
specified type.