H3C S5120-EI Series - Lacp Port-Priority; Lacp Period Short

81
Examples
# Create Layer 2 aggregate interface Bridge-Aggregation 1 and enter its view.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1]
lacp port-priority
Syntax
lacp port-priority port-priority
undo lacp port-priority
View
Ethernet interface view
Default level
2: System level
Parameters
port-priority: Sets a port LACP priority, ranging from 0 to 65535. The smaller the value, the higher the
port LACP priority.
Description
Use the lacp port-priority command to set the LACP priority of a port.
Use the undo lacp port-priority command to restore the default.
The default LACP priority of a port is 32768.
Examples
# Set the port LACP priority of GigabitEthernet 1/0/1 to 64.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lacp port-priority 64
lacp period short
Syntax
lacp period short
undo lacp period
View
Ethernet interface view
Default level
2: System level
Parameters
None