H3C S5120-EI Series - Lldp Compliance Admin-Status Cdp; Lldp Compliance Cdp

218
lldp compliance admin-status cdp
Syntax
lldp compliance admin-status cdp { disable | txrx }
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
disable: Specifies the disable mode, where CDP-compatible LLDP cannot receive or transmit CDP
packets.
txrx: Specifies the TxRx mode, where CDP-compatible LLDP can send and receive CDP packets.
Description
Use the lldp compliance admin-status cdp command to configure the operating mode of
CDP-compatible LLDP on a port or port group.
By default, CDP-compatible LLDP operates in disable mode.
To have your device work with Cisco IP phones, you must enable CDP-compatible LLDP globally and then
configure CDP-compatible LLDP to operate in TxRx mode on the specified port(s).
Related commands: lldp compliance cdp.
Examples
# Configure CDP-compatible LLDP to operate in TxRx mode on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp compliance admin-status cdp txrx
lldp compliance cdp
Syntax
lldp compliance cdp
undo lldp compliance cdp
View
System view
Default level
2: System level
Parameters
None
Description
Use the lldp compliance cdp command to enable CDP compatibility globally.
Use the undo lldp compliance cdp command to restore the default.