225
Examples
# Set the LLDPDU transmit delay to 4 seconds.
<Sysname> system-view
[Sysname] lldp timer tx-delay 4
lldp timer tx-interval
Syntax
lldp timer tx-interval interval
undo lldp timer tx-interval
View
System view
Default level
2: System level
Parameters
interval: Sets the LLDPDU transmit interval, ranging from 5 to 32768 seconds.
Description
Use the lldp timer tx-interval command to set the LLDPDU transmit interval.
Use the undo lldp timer tx-interval command to restore the default.
By default, the LLDPDU transmit interval is 30 seconds.
Examples
# Set the LLDPDU transmit interval to 20 seconds.
<Sysname> system-view
[Sysname] lldp timer tx-interval 20
lldp tlv-enable
Syntax
lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description |
system-name } | dot1-tlv { all | port-vlan-id | protocol-vlan-id [ vlan-id ] | vlan-name [ vlan-id ] } |
dot3-tlv { all | link-aggregation | mac-physic | max-frame-size | power } | med-tlv { all | capability
| inventory | location-id { civic-address device-type country-code { ca-type ca-value }&<1-10> |
elin-address tel-number } | network-policy | power-over-ethernet } }
undo lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description |
system-name } | dot1-tlv { all | port-vlan-id | protocol-vlan-id | vlan-name } | dot3-tlv { all |
link-aggregation | mac
-physic | max-frame-size | power } | med-tlv { all | capability | inventory |
location-id | network-policy | power-over-ethernet } }
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
To Next Page
Loading...
Need help?
General