H3C S5120-EI Series - Page 144

132
Parameters
modulo: Sets the modulo value, ranging from 1 to 16.
Description
Use the vlan-mapping modulo command to map VLANs in the current MST region to MSTIs according
to the specified modulo value, quickly creating a VLAN-to-instance mapping table.
By default, all VLANs are mapped to the CIST (MSTI 0).
You cannot map the same VLAN to different MSTIs. If you map a VLAN that has been mapped to an MSTI
to a new MSTI, the old mapping will be automatically removed.
This command maps each VLAN to the MSTI whose ID is (VLAN ID - 1) %modulo + 1, where (VLAN ID
- 1) %modulo is the modulo operation for (VLAN ID - 1). If the modulo value is 15, for example, then
VLAN 1 will be mapped to MSTI 1, VLAN 2 to MSTI 2, VLAN 15 to MSTI 15, VLAN 16 to MSTI 1, and
so on.
Related commands: region-name, revision-level, display stp region-configuration, check
region-configuration, and active region-configuration.
Examples
# Map VLANs to MSTIs as per modulo 8.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] vlan-mapping modulo 8