H3C S5120-EI Series - Page 150

138
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Table 32 Output description
Field Description
Vlan-interface2 current state
The physical state of a VLAN interface:
• DOWN ( Administratively )—The administrative state of the VLAN
interface is down because it has been shut down with the shutdown
command.
• DOWN—The administrative sate of the VLAN interface is up, but
its physical state is down. The VLAN corresponding to this interface
does not contain any physical port in the UP state (possibly because
the ports are not well connected or the lines have failed).
• UP—Both the administrative state and the physical state of the
VLAN interface are up.
Line protocol current state
The link layer protocol state of a VLAN interface:
• DOWN—The protocol state of this VLAN interface is down, usually
because no IP address is configured.
• UP—The protocol state of this VLAN interface is up.
Description The description string of a VLAN interface.
The Maximum Transmit Unit The MTU of a VLAN interface.
Internet protocol processing :
disabled
The current interface is not capable of processing IP packets. This
information is displayed when the interface is not configured with an IP
address.
Internet Address is
192.168.1.54/24 Primary
The primary IP address of the interface is 192.168.1.54/24. This
information is displayed only if the primary IP address is configured for
the interface.
Internet Address is 6.4.4.4/24 Sub
The secondary IP address of the interface is 6.4.4.4/24. This
information is displayed only if a secondary IP address is configured
for the interface.
IP Packet Frame Type IPv4 outgoing frame format.
Hardware address MAC address corresponding to a VLAN interface.
IPv6 Packet Frame Type IPv6 outgoing frame format.
Last clearing of counters
Time when the reset counts interface vlan-interface command was last
used to clear the interface statistics. Never indicates the reset counters
interface command has never been used on the current interface since
the device’s startup.
Last 300 seconds input: 0 bytes/sec
0 packets/sec
Last 300 seconds output: 0 bytes/sec
0 packets/sec
Average rate of input packets and output packets in the last 300
seconds (in bps and pps). This information is displayed only if the
current VLAN interface supports collecting interface statistics.
0 packets input, 0 bytes, 0 drops
Total number and size (in bytes) of the received packets of the interface
and the number of the dropped packets. This information is displayed
only if the current VLAN interface supports collecting interface
statistics.
0 packets output, 0 bytes, 0 drops
Total number and size (in bytes) of the sent packets of the interface and
the number of the dropped packets. This information is displayed only