What to do if I tried to start a Test with open Safety Circuit on Haefely Test Equipment?
If you attempt to start a test on your Haefely Test Equipment and the safety circuit is open, you should close the safety circuit and then restart the test.
General| Brand | Haefely |
|---|---|
| Model | AXOS |
| Category | Test Equipment |
| Language | English |
General safety precautions for operating the equipment.
Lists five fundamental safety rules for high voltage systems.
Proper grounding procedures for system components.
Requirements for a safe and effective test area.
Safety considerations for connecting to the mains supply.
Guidelines for cleaning and maintaining the instrument safely.
Precautions regarding health effects of electric/magnetic fields and noise.
Specific safety warnings related to the AXOS device operation.
Requirements for personnel training and safety observer roles.
Technical specifications for Surge Combination Wave tests (IEC/EN 61000-4-5).
Technical specifications for Ring Wave tests (IEC/EN 61000-4-12).
Technical specifications for Telecom Wave tests (IEC/EN 61000-4-5).
Technical specifications for EFT/Burst tests (IEC/EN 61000-4-4).
Technical specifications for Voltage Dips & Interrupts tests.
Procedures for system installation and preparing the installation area.
Details on proper ground connection for the system.
Overview of the AXOS device's front panel controls and indicators.
Description of the AXOS device's rear panel connections and ports.
Explanation of the AXOS setup menu options and configurations.
How to load and save predefined test programs.
Introduction to Surge testing according to IEC 61000-4-5.
Details on OCV and SCC waveforms for surge testing.
Explanation of Surge standard and pre-compliance modes.
Configuration options for Surge test properties.
Adjusting transition parameters for Surge testing.
Trigger settings for Surge tests (auto, manual, external).
Overview of Ring Wave standard and pre-compliance modes.
Overview of EFT/Burst standard and pre-compliance modes.
Procedures for creating voltage interrupts without external transformer.
Using external transformer (DIP 116) for voltage dips.
Connecting the AXOS to a remote device via RJ45.
Introduction to common problems and troubleshooting.
Summary of possible alarm messages from AXOS8.
Specific error messages and their causes/actions.
Common logic errors and their solutions.
To Next Page