A-10 888-2629-200 10/6/10
WARNING: Disconnect primary power prior to servicing.
Maxiva ULX COFDM Series
2. Using a small paint brush, apply a coating of Naval Jelly to the torch black and flux
scale on the outside and inside of the line. Let the Naval Jelly set from 10 to 20 min
-
utes.
3. Scrub the line with Scotch Brite or the BBQ Grill pad to loosen the torch black and
flux scale.
4. Flush with water until the Naval Jelly residue is gone.
5. Repeat the process until all the torch black and flux scale is removed.
The first application of the Naval Jelly will remove the torch black and some of the flux
scale. Normally, if vigorous scrubbing is done, repeating the process a second time will
completely clean the line.
To Next Page
Loading...
Need help?
General
