2-18 888-2629-200 10/6/10
WARNING: Disconnect primary power prior to servicing.
Section 2 Installation
Maxiva ULX COFDM Series
Figure 2-2 Pump Module & Heat Exchanger Control Panel Connections
STEP 3 Turn OFF the isolator switch on the pump module control panel and
the isolator switches on the heat exchanger unit. They will be turned
ON later in the procedure to check for wiring problems.
STEP 4 Connect the control and status wires on the cooling control panel
with the supplied multi-conductor cable. These connections are
described on the Electrical Installation Drawing. These low level signals
connect the terminals in the pump module control panel to the
transmitter cabinet.
Table 2-6 is a connection reference chart.
Control
Status &
Mains
AC
to Fans
AC
Mains
AC
To Next Page
Loading...
