Harris Unity XG-100P - Page 77

10515-0372-4200, Rev. R
77
Available parameters vary depending on whether the channel is a digital or analog channel. A digital
channel allows you to receive digital or analog signals. When transmitting on a digital channel, you can
transmit either a digital or analog signal, depending on how the channel is programmed.
1. At main display, press to access the Channel Information menu.
2. Use to scroll through the programmed channel settings.
3. Additional settings can be found by scrolling down.
4. Press to select EDIT CHAN.
Only authorized users should attempt channel editing.
5. Enter the password programmed via RPM. You do not have to re-
enter the
password until you power cycle the radio.
6. Use to select OK.
7. Use to highlight and select the parameter to edit. For digital channels, modify
remaining channel settings:
• CHANNEL NAME - Channel name. Up to 16 alpha-numer
ic characters are
allowed.
• RX FREQUENCY - Receive frequency. Note that
if the new frequency is
invalid, the display reverts back to the old frequency (Table 5-1).
• TX FREQUENCY - Transmit frequency.
• TX POWER – Transmit power. Toggle between LOW and HIGH.
• TALKGROUP – Select a talkgroup for the channel. Talkgroup name cannot
be set here.
• RX NAC - Network Access Code (NAC) radio uses for Normal
squelch in
receive.
• TX NAC - NAC radio transmits to break Normal squelch on receiving radio.
• P25 SQUELCH – Select type the radio uses in receive. Select NORMAL,
SELECTIVE, or MONITOR.
• RX CHAN GUARD – Squelch type
radio uses in receive. Select Noise,
CTCSS, or CDCSS. For a digital channel, the RX CHAN GUARD is used to
receive from a Conventional analog channel that is on the same frequency and
CAUTION