10515-0372-4200, Rev. R
78
uses the selected Channel Guard.
RX CODE - Code radio looks to unmute the speaker on the receiving radio
when CDCSS squelch is used in conventional mode.
RX TONE - Tone radio looks to unmute the speaker on the receiving radio
when CTCSS squelch is used in conventional mode.
8. For analog channel, modify remaining channel settings:
• CHANNEL NAME - Channel name. Up to 16 alpha-
allowed.
• TX FREQUENCY - Transmit frequency.
• TX POWER – Transmit power. Toggle between HIGH and LOW.
• RX CHAN GUARD – Squ
elch type radio uses in receive. Select Noise,
CTCSS, or CDCSS.
RX TONE - Tone radio uses to break selective squelch on receiving radio.
This is available when RX squelch is set to CTCSS.
RX CODE - Code radio uses to break selective squelch on receiving radio.
This is available when RX squelch is set to CDCSS.
RX CHAN GUARD is not available on this screen if it was
enabled from the CALL menu as per Section 3.17.
• TX CHAN GUARD – Squ
elch type radio uses in transmit. Select None,
CTCSS, or CDCSS.
TX TONE - Tone
sent by transmitting radio to allow receiving radio to
unmute when CTCSS squelch is used in conventional mode.
TX CODE -
Code sent by transmitting radio to allow receiving radio to
unmute when CDCSS squelch is used in conventional mode.
TX CHAN GUARD is not available on this screen if it was
enabled from the CALL menu as per Section 3.17.
9. Use to exit menu. An asterisk is displayed in front of the CHANNEL label on
the main display when a channel is edited. The asterisk is NOT shown for TX
Power or Talkgroup changes.
When the only item edited is the TX or RX CHAN GUARD values,
and then CHAN GUARD edit is Disabled, the asterisk goes away and
the channel is no longer considered edited. This is the only editable
item for which this is true.
To Next Page
Loading...
