Safety instructions
8 I3031-14.0 HBM: public Quantum
X
1 Safety instructions
Notice
The safety instructions described here also apply to the
power pack NTX001 and the active backplane BPX001
and BPX002.
Appropriate use
A module with connected transducers is to be used
exclusively for measurement tasks and Test tasks. Use
for any purpose other than the above is deemed to be
non-designated, inappropriate use.
In the interests of safety, the module should only be
operated as described in the Operating Manuals. It is
also essential to comply with the legal and safety
requirements for the application concerned during use.
The same applies to the use of accessories.
Before commissioning the module for the first time, you
must first run a project planning and risk analysis that
takes into account all the safety aspects of automation
technology. This particularly concerns personal and
machine protection.
Additional safety precautions must be taken in plants
where malfunctions could cause major damage, loss of
data or even personal injury. In the event of a fault, these
precautions establish safe operating conditions.
This can be done, for example, by mechanical
interlocking, error signaling, limit value switches, etc.
To Next Page
Loading...
