Safety measures Safety notes
EN 3925-0060 V207-00 MANUAL R03.doc 13
HeMaTech
Prüftechnik
− if the permissible storage or operating temperature is exceeded or fallen short
of.
Installation
The installation measures described in this manual must only be carried out by trained
specialists. The applicable regulations for electrical engineering must in any case be
observed and complied with.
The device must stand in a firm position, protected against vibration.
Avoid locations near heating or air conditioning systems.
Only install the device inside a control cabinet, if adequate ventilation is assured.
Operation
Ensure unrestricted circulation of air around the device. In case of insufficient
ventilation the device will overheat. This may result in severe damage to the
device and further material damage.
Maintenance
The maintenance work described in this manual must only be carried out by trained
specialists. The applicable regulations for electrical engineering must in any case be
observed and complied with.
Only perform the maintenance work described in this instruction manual. Any work
beyond these limitations can cause damage to persons, material or device.
Repair
Do not carry out any repair work that is not explicitly permitted in these operating in-
structions. Consult the customer service department of
HeMaTech Prüftechnik GmbH & Co. KG.
Unprofessionally performed work can cause damage to persons, material or device.
To Next Page
Loading...