Command reference Menu 6. SETTINGS
EN 3925-0060 V207-00 MANUAL R03.doc
HeMaTech
Prüftechnik
3. Pressure control
In this menu you can redetect the settings for the pressure control
(electronic pressure control).
Dialog window SETUP PRESSURE CONTROL before start
Press key F2 to redetect the parameters for the pressure system.
This process takes a few minutes.
You can follow the sequence by the progress bar.
Dialog window SETUP PRESSURE SYSTEM during detection
Once the test device has determined the parameters for the pressure system, the de-
vice is reset and rebooted.
After the boot process the display will show the dialog window specified under
To Next Page
Loading...