The display Working with the program
EN 3925-0060 V207-00 MANUAL R03.doc
HeMaTech
Prüftechnik
Keyboard Shift
The Keyboard Shift displays the selected input mode.
blank = numeric input
A = alphabetic input
S = Shift activates the red marked key board functions.
SA = capital letters.
Help bar
The help bar contains information about the selected process. When the cursor is in
an input field, the info bar will show a brief
description of the command or the possible input.
Working with the program
The device is interactively operated by means of a menu system, which always ends in
a dialog window. The name of the current dialog window appears in inverted charac-
ters (white on black) in the title bar at the top right of the dialog window. The keys,
which can be used for operation, are listed in the command bar at the bottom left. In
the help bar at the bottom right you will find information to the possible entries for the
parameter, on which the cursor is presently positioned.
You can select a menu option by either moving the cursor with the arrow keys, or by
direct input of the cipher in front of the menu. Then confirm the selection by pressing
the ENTER-key.
The program memorizes the settings made last in each dialog window. When you call
up a dialog window again later, the cursor will be at the position that was changed last.
Using the write protection switch
The possible input in a dialog window depends on the position of the write protection
switch on the tester. If the key switch is in vertical position or is pulled off, the device is
in write protected viewing mode and you can only make a few changes concerning the
selection and appearance of saved data.
When you turn the key to the right, you switch on the input mode, and you can change
saved data or enter new data. In input mode the cursor jumps to the position that was
changed last in the displayed dialog window.
You can always close a dialog window by pressing the ESC-key.
NOTE!
If you leave a dialog window in input mode, all entries previously
made in the dialog will be lost.
If you have changed data in one of the dialog windows in input mode and turn the
write protection switch to the left, i.e. locking, these data in the dialog window will be
saved. The device acknowledges this saving process with a short audible signal.
Faulty or incorrectly entered data are automatically corrected by the program or re-
placed by standard parameters specified in the system configuration. In such a case
the user is informed about the changed or replaced data by a warning window.
To Next Page
Loading...