Intended use Introduction
EN 3925-0060 V207-00 MANUAL R03.doc
HeMaTech
Prüftechnik
Intended use
The leak tester 3925-0050 from HeMaTech Prüftechnik is solely intended for profes-
sional use in leak testing of work pieces by means of compressed air. Any use beyond
these limitations is considered unintended. The user solely bears any risks.
Installation and maintenance of the device must only be performed by skilled electrical
engineers.
Type plate
The type plate with model designation and serial number is located on the back of the
device.
You require this information when consulting our Customer Service Department.
Please record this information in the following table, so that it is at hand when needed:
Information about the software version can be found under 6. Settings / 2. System pa-
rameters
Ordering spare parts
Use only original spare parts from HeMaTech Prüftechnik. If you would like to order
accessories or spare parts, you not only need to specify device type and serial number,
but also article number and designation of the required components, which you can
take from the list of consumables and spare parts.
Reporting transport damage
If you discover any transport damage when unpacking the device, you should immedi-
ately contact the forwarding agent to report the loss or damage.
Please ask for a corresponding confirmation and return the package to us together
with this confirmation and the delivery note.
Preparing a return delivery
Pack the article with all accessories (see scope of delivery) in the original packing ma-
terial and return the goods to us, together with an exact fault description and the de-
livery note. Please frank the delivery.
HeMaTech
Prüftechnik GmbH & Co. KG
Siemensstraße 7 D 71409 Schwaikheim
Phone: +49 (0)71 95 – 13 69 0
Fax.: +49 (0)71 95 – 13 69 29
www.hematech.de
Type: ________________________________
Serial-No.: ________________________________
Voltage: ________________________________ V
To Next Page
Loading...