Menu 3. SETUP Command reference
EN 3925-0060 V207-00 MANUAL R03.doc
HeMaTech
Prüftechnik
fields from: und to:, and confirm these individually with the ENTER-key.
Possible entries range from 1 … 10.
Target:
Press the keys – and + to determine the desired TARGET for the data output:
You can select between:
Ser #1,
Ser #2,
USB-Stick.
Confirm the selection by pressing the ENTER-key.
Format:
Press the keys – and + to determine the desired FROMAT for the data output:
You can select between:
LINE printer.
Confirm the selection by pressing the ENTER-key.
You can output the selected program parameter through the selected interface by
pressing the F2-key.
The message Print data is active! is display in the display.
Press the ESC-key to exit the menu.
NOTE!
With a data output to a USB stick or external hard drive a file will be
automatically generated. The file name consists of the serial number
and the ending SEQ.
e.g. 10100100.SEQ
If a file with same file name already exists, the file will be opened and
the data append to the file.
To Next Page
Loading...