HIKVISION iDS-9000HQHI-M8/S Series - Page 132

One-Touch Creaon
One-touch conguraon creates the disk array. By default, the array type created by one-touch
conguraon is RAID 5.
Before You Start
Install at least 3 HDDs. If more than 10 HDDs are installed, 2 arrays will be created. To maintain
reliability and stability running of the HDDs, it is recommended to use of enterprise-level HDDs of
the same model and capacity.
Steps
1.
Go to Storage → Advanced .
2.
Check Enable RAID.
3.
Click Apply and reboot the device to have
sengs take eect.
4.
Aer reboot, go to Storage → RAID Setup → Physical Disk .
5.
Click One-touch
Cong.
6.
Edit Array Name and click OK to start conguring.
Note
If you install 4 or more HDDs, a hot spare disk for array rebuilding will be created.
7.
Oponal: The video recorder will automacally inialize the created array. Go to Storage →
RAID Setup → Array to view the informaon of the created array.
Manual
Creaon
Manually create a RAID 0, RAID 1, RAID 5, RAID 6, or RAID 10 array.
Steps
1.
Go to Storage → Advanced .
2.
Check Enable RAID.
3.
Click Apply and reboot the device to have
sengs take eect.
4.
Aer reboot, go to Storage → RAID Setup → Physical Disk .
5.
Click Create.
Digital Video Recorder User Manual
108