Hioki 3541 - Page 122

8.5 Message List
116
:SYSTem:TEMPerature:PARameter?
(<V1>,<T1>,<V2>, <T2>)
Queries the analog input scaling constant
settings
135
Self-Calibration
:SYSTem:CALibration
Execute Self-Calibration
136
:SYSTem:CALibration:AUTO
1, 0, ON or OFF Sets automatic self-calibration
136
:SYSTem:CALibration:AUTO?
(ON or OFF)
Queries the automatic self-calibration
setting
136
Key Beeper
:SYSTem:BEEPer:STATe
1, 0, ON or OFF Sets the key beeper
136
:SYSTem:BEEPer:STATe?
(ON or OFF) Queries the key beeper setting
136
Line Frequency
:SYSTem:LFRequency
50 or 60 Selects the AC line frequency
136
:SYSTem:LFRequency?
(50 or 60) Queries the AC line frequency selection
136
Key-Lock
:SYSTem:KLOCk
1, 0, ON or OFF Sets the key-lock
137
:SYSTem:KLOCk?
(ON or OFF) Queries the key-lock setting
137
Saving and Loading Measurement Setting States
:SYSTem:SAVE
<Table No.> Saves the measurement setting state
137
:SYSTem:LOAD
<Table No.> Loads a measurement setting state
137
Header Present
:SYSTem:HEADer
1, 0, ON or OFF Sets header present
137
:SYSTem:HEADer?
(ON or OFF) Queries the header present setting
137
ERR Output
:SYSTem:ERRor
SYNChronous or
ASYNchronous
Sets error output timing
137
:SYSTem:ERRor?
(SYNCHRONOUS or
ASYNCHRONOUS)
Queries the error output timing setting
137
External I/O Output
:SYSTem:EXTernalout
BIN or BCD Selects BIN or BCD
138
:SYSTem:EXTernalout?
(BIN or BCD) Queries the external I/O output selection
138
Delimiter (Terminator)
:SYSTem:TERMinator
0 or 1 Sets the command delimiter
138
:SYSTem:TERMinator?
(0 or 1) Queries the command delimiter setting
138
System Reset
:SYSTem:RESet
Executes a system reset, including saved
measurement setting state data
138
Message ([ ] = optional)
Data Contents
( ) = response data
Description
Ref
page