132
_____________________________________________________________________
7.5 Scaling Function
______________________________________________________________
Flashing cursor
OFF
Scaling not used
SCI
Scaling used (specify exponent as integer)
ENG
Scaling used (specify exponent as multiple of 3)
Flashing cursor
(3) Set the scaling settings for channels.
Move the flashing cursor as shown in the figure below and
use the
buttons to make a setting.
(4) When specifying by conversion ratio, enter the
scaling (numeric value) and offset value.
When specifying by two points, enter two points on the
gradient with different values.
1. Move the flashing cursor to the item to be entered.
2. Press the buttons to display the numeric entry window.
Move the cursor to the digit to be set, and press the
buttons to make a setting.
3. When finished settings, move the flashing cursor to the
OK
position and press the buttons or the
START
button to
accept the entry.
To cancel settings, move the flashing cursor to the
CANCEL
position and press the buttons or the
STOP
button to
cancel the entry.
To Next Page
Loading...
