Hioki 8807-01 - Page 157

133
_____________________________________________________________________
7.5 Scaling Function
______________________________________________________________
Flashing cursor
Flashing cursor
Flashing cursor
(5) Set the scaling units.
Move the flashing cursor to the channel for which the products
are to be set. Enter the products. Refer to Section 11.3.3 Text
Entry Procedure for the product entry procedure.
(6) Exit the Scaling Screen.
When finished with scaling settings, move the flashing
cursor to the
Back
position and press the buttons or the
SET
button to return to the Channel Screen.
Copying Scaling Settings
Move the flashing cursor to the position shown in the
figure. Pressing the
button then copies the settings from
the channel immediately above. Pressing the
button
again copies the settings from the channel above that.
Similarly, pressing the
button copies the settings from
the following channel.