Hioki 8808-51 - Page 141

117
_____________________________________________________________________
7.2 Operation Sequence (Input Channel Setting)
______________________________________________________________
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
APP
IND
Settings on the Environment Screen
Settings on the
Waveform Screen
Settings on the
Waveform Screen
Voltage axis range
Waveform display color
Magnification/compressio
n ratio along the voltage
axis
Zero position
Input coupling
Set the display color for the waveform.
Set the voltage axis range for channel.
Set the input coupling for the input
signal.
Set the magnification/compression
ratio along the voltage axis for channel
to display or record data.
Set the zero voltage position.
Press the DISP button to display the Waveform Screen.
Press the Channel Select button of the channel to be set,
to display the Settings window. Refer to section 7.4.
Settings on the Environment Screen
Logic recording width
The width of the logic waveform can be
set to wide or narrow.
Refer to section 10.1.5
Set the low-pass filter.
DISP
Low-pass filter