46
_____________________________________________________________________
4.3 Setting Items
______________________________________________________________
Flashing cursor
OFF
Disables the auto print.
ON
Enables the auto print.
NOTE
When cursor A and B are enabled, partial printing is executed.
For using the A/B cursors, refer to Section 9.1.
When the roll mode is enabled and the time-axis range is 10
ms/DIV to 5 min/DIV, data is displayed and printed
simultaneously.
The printer cannot be used with alkaline batteries: use either the
9418-15 AC ADAPTER (SA145A-1240V-6, SINO
AMERICAN) or 9447 BATTERY PACK when using the
printer.
4.3.7 Setting the Auto Print Function
This function is available when the 8992
PRINTER UNIT
is
connected. Printout is carried out automatically after a
waveform has been captured for the specified recording
length.
Procedure
Status Screen
1. Press the
SET
button to display the Status Screen.
2. Move the flashing cursor to
Auto Print
and set to ON or OFF
using the
buttons.
To Next Page
Loading...
