Hioki 8808-51 - Channel Usage Settings

53
_____________________________________________________________________
4.8 Extended Status Screen Setup (MEM)
______________________________________________________________
Flashing cursor
1CH
Internal memory is allocated to channel 1, so
measurement data on channels 2 and above
cannot be stored to internal memory. Only
Channel A can be used for logic.
2CH
Internal memory is allocated to channel 1 and 2, so
measurement data on channels 3 and above cannot
be stored to internal memory. Channels A and B
can be used for logic.
4CH
Internal memory is allocated for the four channels
(Model 8808-01, 8808-51).
Channels A and B can be used for logic.
4.8.1 Channel Usage Settings
Set segmenting of measurement data memory.
The record length can be made longer when using fewer
channels.
Procedure
Extended Status Screen
1. Press the
SET
button to display the Status Screen.
2. Move the flashing cursor to
Extended Status
and display the
Extended Status Screen using the
buttons.
3. Move the flashing cursor to
Use Channel
and select channel
using the
buttons.