Hioki 8808-51 - RS&COPY Screen (SYSTEM); Screen Copy Output Destination

197
_____________________________________________________________________
10.3 RS&COPY Screen (SYSTEM)
______________________________________________________________
Flashing cursor
OFF
Screen copy is disabled.
ON
Screen copy is enabled.
10.3 RS&COPY Screen (SYSTEM)
10.3.1 Screen Copy Output Destination
The destination for output of displayed data by the
COPY
button can be specified.
Procedure
RS&COPY Screen
(1) Enable screen copy.
1. Press the
SYSTEM
button to display the RS&COPY Screen.
2. Move the flashing cursor to the position shown in the
figure below and use the
buttons to make a setting.