191
_____________________________________________________________________
10.1 Environment Screen (SYSTEM)
______________________________________________________________
Flashing cursor
OFF
The backlight saver is disabled.
1to30min
The backlight time-out in minutes. The light
turns off automatically after the set time.
When using the alkaline batteries or Battery
pack, set to 1 to 5 minutes.
NOTE
If the backlight time-out occurs while measuring, the green LED
remains lit. If the backlight time-out occurs while setting, the
green LED blinks.
10.1.6 Backlight Saver
When this function is enabled, LCD back lighting is turned
off automatically if no button is pressed for the preset
interval.
Pressing any button will turn the display on again.
This increases the service life of the back light.
Procedure
Environment Screen
1. Press the
SYSTEM
button to display the Environment
Screen.
2. Move the flashing cursor to
Back Light Saver
and use the
buttons to make a setting.
To Next Page
Loading...
