Hioki 8808-51 - Setting the Low-Pass Filter

126
_____________________________________________________________________
7.3 Setting the Channel Screen
______________________________________________________________
Flashing cursor
OFF
No low-pass filter is connected.
5Hz
Connect a filter with a cutoff frequency of 5 Hz
500 Hz
Connect a filter with a cutoff frequency of 500 Hz



Filter: OFF Filter: 500 Hz
7.3.7 Setting the Low-Pass Filter
Effective for removing unneeded high-frequency
components.
Procedure
Channel Screen
1. Press the
SET
button to display the Channel Screen.
2. Move the flashing cursor to the desired channel position.
3. Use the
buttons to make a setting.