Hioki 8808-51 - Chapter 15 Logic and Analog Inputs; Logic Inputs

287
_____________________________________________________________________
15.1 Logic Inputs
______________________________________________________________
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
AP
P
IND
WARNING
Two probes can be connected to the Logic Input
section, but the probes are not isolated from each
other or from the frame ground of the product
(common ground). Therefore, applying voltages with
different ground levels can result in a short circuit,
depending on the probe type.
Logic probes other than those supplied by HIOKI
should not be connected to the logic inputs.
NOTE
Connect the 9323 CONVERSION CABLE to the product to use
with the 9320, 9321 LOGIC PROBE.
Chapter 15
Logic and Analog Inputs
15.1 Logic Inputs
Logic Probe Connection
The logic input is located on the upper side of the product.
Up to two probes can be connected.
One logic probe can record up to four channels, so up to
eight logic waveforms can be recorded with two probes.