228
_____________________________________________________________________
11.6 Printing Procedure
______________________________________________________________
11.6.4 Partial Print
This function prints the waveform between the A and B
cursors (vertical or trace cursors). The function is available
also when the A/B cursors are currently outside the range
displayed on screen. Printing is possible also when the
print format is currently set to "Logging". For details
regarding the use of the A/B cursors, refer to Section 9.1.
Memory recorder, instantaneous waveform in RMS
Specified range (out of entire data recorded from a
measurement) is printed.
Recorder, RMS recorder
The specified area of internal memory immediately before
the end of measurement.
Recorder: 400 DIV
RMS recorder: 200 DIV
Procedure
Waveform Screen
1. Press the
DISP
button to display the Waveform Screen.
2. Position cursor A at the start point of the range to be
printed.
3. Specify the end point of the range with cursor B.
(Move cursor B (or A) to the right. When the cursor is at
the rightmost edge of the screen, the waveform scrolls to
the left, and cursor A (or B) scrolls with it.)
4. Then press the
PRINT
button.
The specified range is printed, also if cursor A (or B) is
currently off screen.
To Next Page
Loading...
