Hioki 8808-51 - Using the Line Cursors (Horizontal)

175
_____________________________________________________________________
9.1 Using the A/B Cursors
______________________________________________________________
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
APP
IND
12 34
OFF
Disable A/B cursors
Line cursor (vertical) (t and 1/t are displayed)
Line cursor (horizontal) (v is displayed)
+
Trace cursor (the point where the cursor crosses the
waveform)
A
Use the cursor A only
A-B
Move the cursor A only
A-
B
Move the cursor B only
A
-
B
Move simultaneously both cursors A and B
9.1.2 Using the Line Cursors (Horizontal)
Used to read a voltage value of the specified channel. A/B
cursor can be specified a different channel.
Procedure
Waveform Screen
1. Press the
DISP
button to display the Waveform Screen.
2. When position 1 shown in the figure below is selected to
SCRL
(scroll), use the buttons to set to
CSR
(cursor).
Pressing the
and buttons simultaneously also changes
setting.
3. Move the flashing cursor to position 2 and select
(horizontal line cursor).
4. Move the flashing cursor to position 3 and select the cursor
to be moved.
5. Move the flashing cursor to position 4 and select the
channel number to be measured by the cursors.
6. Move the A/B cursors using the
scrolling button to
view the display. Pressing the
buttons moves the
cursors faster.