Hioki 8808-51 - Setting the Roll Mode

54
_____________________________________________________________________
4.8 Extended Status Screen Setup (MEM)
______________________________________________________________
Flashing cursor
OFF
Disables the roll mode.
ON
Enables the roll mode.
NOTE
Even if set to ON, the Roll Mode is inoperative when the time
axis range is set faster than 10 ms/div.
When Roll mode is set to ON, the settings for sequential saving
is automatically turned OFF.
4.8.2 Setting the Roll Mode
This mode can be used at a time axis range setting of 10
ms/DIV to 5 min/DIV. When roll mode is set to ON, the
waveform is displayed immediately at the start of recording
(the screen scrolls).
When the 8992 PRINTER UNIT is connected and the Roll
Mode and Auto Print are enabled, printing occurs
concurrently with waveform display.
Procedure
Extended Status Screen
1. Press the
SET
button to display the Status Screen.
2. Move the flashing cursor to
Extended Status
and display the
Extended Status Screen using the
buttons.
3. Move the flashing cursor to
Roll Mode
and set to ON or OFF
using the
buttons.