Hioki 8808-51 - Environment Screen (SYSTEM); START Button Activation

186
_____________________________________________________________________
10.1 Environment Screen (SYSTEM)
______________________________________________________________
Flashing cursor
One Push
Press the START button once to start
measurement.
Two Push
Press the START button twice to start
measurement.
2s Push
Press the START button and hold it for two
seconds to start measurement.
NOTE
When the START button activation condition is set to "2s
Push", the display shows "Waiting for 2s...." After holding for 2
seconds, the message disappears and measurement starts.
10.1 Environment Screen (SYSTEM)
10.1.1 START Button Activation
The
START
button normally initiates measurement when
pressed once, but to avoid erroneous operation, the
activation condition of this button can be modified.
Procedure
Environment Screen
1. Press the
SYSTEM
button to display the Environment
Screen.
2. Move the flashing cursor to
START Key Acceptance
and use
the
buttons to make a setting.