Hioki 8808-51 - Page 152

128
_____________________________________________________________________
7.3 Setting the Channel Screen
______________________________________________________________
Flashing cursor
POSN 1
POSN 2
POSN 3
POSN 4
POSN 1
POSN 2
POSN 3
POSN 4
POSN 5
POSN 6
POSN 7
POSN 8
Wide
Narrow
Logic Recording Width
(3) Select the display position for the logic waveform.
Move the flashing cursor to the position shown in the
figure below and set the display position using the
buttons.
Logic Waveform Display Position
Selection of the display position differs according to the
logic recording width setting on the Environment Screen.
When Wide is selected choose position 1 to 4, or when
Narrow is selected choose position 1 to 8.
For details, refer to Section 10.1.5.