20
_____________________________________________________________________
2.8 Connecting the 8992 PRINTER UNIT
______________________________________________________________
NOTE
When the stock cover is fully open, attempting to force it open
further may damage the cover.
The paper may jam if it is not aligned with the roller.
Always place the product in the head-up condition when it is to
be transported or stored for an extended period of time. If the
product is left idle for a long time with the head pressing on the
roller, the roller may be deformed, resulting in uneven printing.
Be careful to correctly orient the recording paper. Nothing will
be printed if the recording paper is loaded with the wrong side
facing the print head.
We recommend using only the specified 9234 RECORDING
PAPER.
5. Pull the end of the recording paper
out at least 10 cm, and make sure
that it is positioned quite straight.
6. Put down the head up/down lever.
7. Pull the recording paper to the
outside through the printer exit slot
in the stock cover.
8. Close the stock cover, and finish by
tearing off the recording paper
against the edge of the printer exit
slot.
To Next Page
Loading...
