59
_____________________________________________________________________
4.8 Extended Status Screen Setup (MEM)
______________________________________________________________
Number of
Recording channels
length (DIV)
1 2 4
Instantaneous
waveform
recording *
20 32 32 32 16
50 32 32 16 8
100 32 16 8 4
200 16 8 4 2
400 8 4 2 ---
800 4 2 --- ---
1600 2 --- --- ---
Flashing cursor
OFF
After all blocks are recorded, the waveform of the last
block only is displayed.
ON
Each block is recorded and displayed.
The recording length and maximum number of divisions are
automatically determined according to the number of
available channels, as shown in the tables below. Refer to
Section 4.8.1 for details.
Maximum number of divisions
*This shows the number of divisions for the instantaneous
waveform recording (Memory Recording) of the RMS Recorder
function.
(5) Follow-up waveform display
Enabling Subsequent Waveform Display causes the
waveforms that were input to each block following a trigger
event during Sequential Save to be displayed one by one
(resulting in longer dead time).
Move the flashing cursor to
Following
and set to ON or OFF
using the
buttons.
To Next Page
Loading...
