Hioki 8808-51 - Page 85

61
_____________________________________________________________________
4.8 Extended Status Screen Setup (MEM)
______________________________________________________________
Flashing cursor
Flashing cursor
(8) Set the last block
Move the flashing cursor to
End Block
and set the last block
to be displayed using the
buttons.
(9) Finishing sequential save setting
When finished setting, move the flashing cursor to
Back
and
press the
buttons or
SET
button to return to the Status
Screen.
(10) Stored block display procedure
Extended Status Screen
1. Move the flashing cursor to
Display Block
.
2. Specify the block to be displayed using the
buttons.
The blocks shown by
indicate that measured data has
been saved to the blocks.