63
_____________________________________________________________________
4.8 Extended Status Screen Setup (MEM)
______________________________________________________________
Last block
Measurement
start
Waveform display
Measurement
end
Trigger
mode
REPEAT
AUTO
STOP
SINGLE
First block
Auto saving
Auto print
Relation between trigger mode and sequential save function
Press the
START
button to start measurement, and
LED lights in green. Data recording starts when trigger
conditions are met.
First block is stored by trigger setting.
The following waveform display ON:
waveform is displayed.
The following waveform display OFF:
waveform is not displayed.
Last block is stored by trigger setting.
The following waveform display ON:
waveform is displayed.
The following waveform display OFF:
waveform is not displayed.
Displays last block waveform.
When auto saving is enabled, waveforms in all blocks
are saved in a batch.
When auto printing is enabled, all blocks are printed
from the first block while individual blocks are
displayed.
Trigger mode: REP/AUTO
Activates the trigger waiting condition. Input resumes
when the trigger conditions are met.
Trigger mode: SING
Measurement can be aborted by pressing the
STOP
button twice (automatic printing will not execute).
Trigger mode: REP/AUTO
During measurement, pressing the
STOP
button once
records up to the end of the block (waveform display,
printing and auto-save are executed).
Measurement can be aborted by pressing the
STOP
button twice (automatic printing will not execute).
To Next Page
Loading...
