Hioki PW3390 - Page 131

5.7 Trend Function
123
5
Chapter 5 Operating Functions
Setting the value that corresponds to the reference position (percent of full scale)
• The formula displayed above allows you to check the value of the plotted item that corre-
sponds to the reference position.
• The [Base %] setting is not available while using the [AUTO] scale setting. The value that
corresponds to the reference position is determined automatically based on the maximum
and minimum values for the waveform being graphed.
•The [Base %] setting is not available while using the [MANUAL] scale setting.
Only values between the set maximum and minimum values are graphed.
Select [Base %] for
the graph number you
wish to change.
Use F keys to set.
Base%:
-300.00% to +300.00%
Setting the trend graph maximum and minimum values
• The [MAX] and [MIN] settings are not available when using a scale setting other than
[MANUAL].
• No trend graph will be generated if the [MAX] value is less than the
[MIN] value, or if the
[MIN] value is greater than the [MAX] value.
Select [MAX] or [MIN]
for the graph number
you wish to change.
Open a value entry dialog box with
the key or key.