10.2 Basic Specifications
198
(5) RS-232C Interface
Method RS-232C
[EIA RS-232D], [CCITT V.24], [JIS X5101] compliant
Connector D-sub9 pin connector ×1
Connection destination PC (simultaneous use of USB and LAN not supported; order of precedence with simultaneous con-
nection: USB > LAN > RS-232C.)
Communication format Full duplex, start-stop synchronization, 8-bit data, no parity, one stop bit, hardware flow control,
CR+LF delimiter
Communication speeds 9600 bps, 19200 bps, 38400 bps
Function Command control, Bluetooth
logger connectivity (simultaneous use not supported)
(6) Synchronization Control Interface
Signal contents One-second clock, integration START/STOP, DATA RESET, EVENT
Connector types IN: 9-pin round connector ×1
OUT: 8-pin round connector ×1
Signal 5 V CMOS
Max. input ±20 V
Max. signal delay 2 s (rising edge)
(7) External Control Interface
Connector types 9-pin round connector ×1 ; also used as synchronization control interface
Pin assignments Pin 1: Data reset
Pin 2: Integration start/stop
Pin 4: Event
Pin 7: Ground
Electrical specifications 0 V/5 V (2.5 V to 5 V) logic signal, or contact signal with contacts shorted/open
Function Data reset: Same operation as the DATA RESET key on the control panel
Integration start/stop: Same operation as the START/STOP key on the control panel
Event: Same operation as the event set as the synchronization control function’s synchronization
event (Cannot be used at the same time as synchronization control.)
To Next Page
Loading...
