Figure 5-81 Removing the connector cover
3. Insert the pass through mezzanine component into server blade
connector and storage expansion blade connector straight downward.
Make sure to insert the arch shaped guide bracket into edges of server
blade and expansion blade.
Figure 5-82 Inserting the pass through mezzanine component
4. Push the portions indicated PUSH on the pass through mezzanine card
and cable connector to connect to the server blade connector and
expansion blade connector, respectively.
5. Close the latches on the pass through mezzanine card.
5-66
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
