14. Press Enter when Insert media for update, and Input Enter key.
(c:Cancel) is indicated.
15. The Data file lines, which indicate the Firmware files in the CNA FW
Update Media, are indicated.
When the FW ver of the other CNA products, which were indicated in
step 8, differed from the version of the replaced CNA product, enter the
Number corresponding to the FW ver of the other CNA products in
Select No. line, and then press Enter.
When only the replaced CNA mezzanine card is installed in the server
blade, enter the Number corresponding to the latest firmware version
in Select No. line, and then press Enter.
The message, Starting update of F/W data ..., is indicated and the
updating firmware starts. (It takes about two to three minutes.)
Configuring Emulex mezzanine card
7-77
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
