Hitachi Compute Blade 500 Series - Page 296

ID
Operation
category
Recording trigger Message
3803 Configuration
Access
Changing power supply
module settings.
On Power supply module, setting is
changed. Channel:xxx Category:xxx
Detail:xxx Value:xxx
3804 Changing power supply
module settings
On Power supply module N, setting
is changed. Channel:xxx
Category:xxx Detail:xxx Value:xxx
3806 Changing management
LAN settings for
management module.
Management LAN setting is
changed. Channel:xxx Category:xxx
Value:xxx
3808 Changing management
LAN settings for switch
module.
On Switch module N, LAN setting is
changed. Channel:xxx Category:xxx
Value:xxx
3809 Changing management
LAN settings for switch
module.
On Switch module N, LAN setting is
changed. (Apply Management
module setting) Channel:xxx
380E Changing VLAN
settings.
VLAN setting is changed.(Move
port) Channel:xxx Target:xxx
Partition:xxx
Switch module:xxx VLAN ID:xxx
380F Creating VLAN settings. VLAN is created on management
LAN port. Channel:xxx VLAN ID:xxx
Ext port:xxx
3810 Removing VLAN
settings.
VLAN is removed on management
LAN port. Channel:xxx VLAN ID:xxx
3821 Request of restoring to
factory default settings
for management
module.
Reset management module to
factory default setting. Channel:xxx
Category:xxx
3829 Changing JP1/SC/BSM
cooperation settings.
JP1/SC/BSM connection setting is
changed.(command port#)
Channel:xxx Value:xxx
382B Changing E-mail
settings.
E-mail setting is changed.
Channel:xxx Category:xxx
Detail:xxx Value:xxx
382E Changing SNMP
settings.
SNMP setting is changed.
Channel:xxx Category:xxx
Detail:xxx Value:xxx
382F Removing SNMP
setting.
SNMP setting is removed
Channel:xxx Category:xxx
Number:xxx
3830 Changing service
settings.
xxx service setting is changed.
Channel:xxx Category:xxx
Value:xxx
3832 Creating a pair of SSH
host key.
SSH host key pair is created.
Channel:xxx
2-272
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide