GYNECOLOGIC SAMPLE PREPARATION
4.4
ThinPrep™ 5000 Processor with AutoLoader Operator’s Manual
Collect Gynecologic Sample, Using the Endocervical Brush/Spatula Device
Physician/clinician instructions for collecting gynecologic samples.
1.
Obtain
an adequate sampling from the ectocervix using a
plastic
spatula.
2.
Rinse
the spatula as quickly as possible into the PreservCyt
™
Solution vial by swirling the spatula vigorously in the vial
10 times. Discard the spatula.
3.
Obtain
an adequate sampling from the endocervix using an
endocervical brush device. Insert brush into the cervix until only
the bottom-most fibers are exposed. Slowly rotate 1/4 or 1/2 turn
in one direction. DO NOT OVER-ROTATE.
4.
Rinse
the brush as quickly as possible in the PreservCyt
Solution by rotating the device in the solution 10 times while
pushing against the PreservCyt vial wall. Swirl vigorously to
further release material. Discard the brush.
5.
Tighten
the cap so that the torque line on the cap passes the
torque line on the vial.
6. Record
the patient’s name and ID number on the vial.
Record
the patient information and medical history on the
cytology requisition form.
Note:
If the sample is to be processed immediately, allow the
sample to stand in the PreservCyt Solution vial for at least
15 minutes before processing.
If the sample is to be sent elsewhere for processing, continue with
the next step.
7.
Place
the vial and requisition in a specimen bag for transport to
the laboratory.
Refer to the instructions provided with the collection device for warnings,
contraindications, and limitations associated with specimen collection.
To Next Page
Loading...
