ThinPrep™ 5000 Processor with AutoLoader Operator’s Manual
8.17
MAINTENANCE
CHANGE ABSORBENT PADS
There are two absorbent pads in the processing compartment of the instrument that absorb drips that
may result from processing. One is located at the base of the filter plug and the other is on the top of
the evaporative cover over the fixative bath carousel. See Figure 8-18.
Figure 8-18 Absorbent Pads
Use the Clean System feature to help move instrument mechanisms out of the way. See “Clean
System” on page 8.3.
Replace the pads once a year, or as desired. The pads can be disposed of as regular waste, unless they
are dripping wet, then dispose of as hazardous waste.
When the pads are replaced, notice that one side is rough and absorbent and one side is smooth and
finished. The rough side should face outward to catch any drips.
Refer to Ordering Information for ordering pads.
On a more frequent basis if desired, the pads can be washed and returned to the instrument. Clean
with soap and water. Or soak in a diluted bleach rinse followed by a 70% alcohol rinse.
Filter plug Evaporative cover, fixative bath
Rough side
To Next Page
Loading...
